Ultrasonic Cleaning of Spinnerets
Spinnerets are the precision plates at the heart of synthetic fibre production. Molten polymer is forced through hundreds to thousands of micron-scale holes to form filaments; each of these holes must stay open and its geometry flawless.
In polyester, polyamide and polypropylene production, spinneret holes are usually 0.1–0.5 millimetre in diameter and are sometimes profiled (trilobal or hollow cross-sections, for example). During production, polymer residue, carbonised and degraded polymer, additives (such as titanium dioxide) and spin finish build up inside the holes. Blocked or narrowed holes cause filament defects, breaks and denier (fineness) irregularity.
What makes cleaning difficult?
The unbreakable rule of spinneret cleaning is never to change the geometry of the hole. The slightest enlargement or deformation of a micron-scale hole ruins the fibre cross-section and therefore every property of the yarn. Yet:
- Pre-cleaning methods such as vacuum pyrolysis, a triethylene glycol bath or a salt bath remove the bulk polymer, but the fine residue inside the capillary hole often stays in place.
- A static ultrasonic bath struggles to rinse these micron-scale capillaries: an air lock forms inside the hole, and since there is no flow from the inside out, the dissolved residue cannot leave the hole.
How does the MCH Rosd 170 solve this?
Thanks to its special mechanical design and its special movement capability within the ultrasonic bath, the MCH Rosd 170 targets exactly this capillary-flow problem:
- Pumping and forced flow: The special movement capability continuously carries fresh bath into each hole and drives the dissolved residue out of the hole.
- Air evacuation: The special mechanical design constantly changes the part's position within the bath, releasing the trapped air and letting the ultrasonic effect reach inside the capillary.
- Continuous bath renewal: The contaminated liquid in the hole is continuously expelled and replaced by fresh bath with a high chemical concentration.
Precision is managed by dual frequency: 40 kHz high frequency provides gentle cleaning without stressing the delicate micron holes, while for heavier residue 27 kHz can be engaged. This completes the cleaning while preserving the hole geometry. Custom fixtures hold the spinneret packs securely; the machine is ideal for the final cleaning stage after pyrolysis or similar pre-cleaning.
Relevant MCH Rosd 170 features
- Pumping effect into the capillary through its special movement capability
- 27 / 40 kHz dual frequency — adjustable cleaning for delicate holes
- Concentration kept inside the hole through continuous bath renewal
- Custom-designed spinneret fixtures for different die/spinneret types
- Manufacturing in the required size and capacity
Through the sweeping effect created by its special mechanical design and special movement capability within the ultrasonic bath, the micron-scale holes of the spinneret are cleaned with great precision; the holes open fully, their geometry is preserved and spinning performance becomes consistent. At the end of washing, the sweeping process is still active as the spinneret leaves the bath, so it comes out clean carrying a minimum of dirt. The result is fewer breaks and less scrap, and directly increased production and quality.
Sectors: Synthetic yarn and fibre · Nonwoven · Technical textiles
Machem + Molkim — Turn-key solution: The MCH Rosd 170 is part of a turn-key solution jointly developed by Machem and Molkim: machine and chemical are designed together, end to end, as a complete process and offered from a single source as a definitive solution. The entire process is controlled by PLC; thanks to its special mechanical design and special movement capability within the ultrasonic bath, the holes are cleaned with great precision, which directly enables increases in production and quality.
If you would like to see the solution the MCH Rosd 170 offers for cleaning your spinnerets, get in touch with us.
Language
Türkçe
English
Deutsch
Русский
Français
عربي